2008 Mazda Mazda3

2008 Mazda3 4-DR.

Overall

Not Rated

Front Crash

Not Rated

Side Crash

Not Rated

Rollover

Not Rated

2008 Mazda3 5-DR. Hatchback w/SAB

Overall

Not Rated

Front Crash

Not Rated

Side Crash

Not Rated

Rollover

Not Rated

VISIBILITY:WINDSHIELD WIPER/WASHER:MOTOR

MAZDA IS RECALLING CERTAIN MODEL YEAR 2008-2009 MAZDA3 AND MAZDASPEED3 VEHICLES MANUFACTURED FROM JANUARY 7, 2008, THROUGH NOVEMBER 28, 2008. THE GROUND TERMINAL OF THE WINDSHIELD WIPER MOTOR MAY HAVE BEEN INADVERTENTLY BENT DURING ASSEMBLY. IF THIS CONDITION EXISTS THEN OVER TIME THE ELECTRICAL RESISTANCE OF THE MOTOR CIRCUIT MAY INCREASE UP TO A POINT THAT THE WINDSHIELD WIPERS WOULD NOT WORK.

Campaign: 11V329000

STEERING:ELECTRIC POWER ASSIST SYSTEM

MAZDA IS RECALLING CERTAIN MODEL YEAR 2007-2009 MAZDA3 AND MAZDA5 VEHICLES MANUFACTURED FROM APRIL 2, 2007 THROUGH NOVEMBER 30, 2008. THESE VEHICLES MAY HAVE A CONDITION IN WHICH A SUDDEN LOSS OF POWER STEERING ASSIST COULD OCCUR AT ANY TIME WHILE DRIVING THE VEHICLE.

Campaign: 10V374000

EQUIPMENT

THULE, INC. IS RECALLING 2,323 OWNER-INSTALLED ROOF-MOUNTED FIT KITS, MODELS 3068 AND 3069, MANUFACTURED BETWEEN JANUARY 1, 2008 AND FEBRUARY 28, 2009 THAT ARE USED WITH THULE PODIUM FOOT PACKS, MODELS 460 AND 460R. THESE FIT KITS WERE SOLD AS AFTERMARKET EQUIPMENT FOR USE ON THE VEHICLES LISTED ABOVE. THE BOLT(S) USED TO SECURE THE FOOT TO THE VEHICLE WAS MANUFACTURED TO A HARDNESS THAT MAY CAUSE THE BOLT(S) TO BE BRITTLE AND POTENTIALLY BREAK UNDER STRESS.

Campaign: 09E011000

STEERING

The power steering on my 2008 Mazda 3 went out. I took it to a mechanic shop who diagnosed the power steering pump is creating pressure that is getting to the rack and pinion and the fluid is just bouncing off of the rack and pinion and the computer system does not know how to function, so the power steering is not working.

FUEL/PROPULSION SYSTEM

There is a plastic ring on top of the gas tank that holds down the fuel pump.I filled up my tank and looked under the car afterwards,at this time I noticed gas coming out from the tank until is was flushed with the top and then stopped.I pulled out the back seat,found the inspection plate and for sure this was and did happen,now nothing could be done at the time because the inspection plat hole was smaller than the ring,the tank had to be dropped.It had to be fixed,about $600.00 later and tank filled up it was repaired.I still have the ring and pictures where the ring was cracked around the threads.send me a e-mail address and I can send pictures and a copy of the bill.later on I went on line and discovered that I was not the only one.This happen about 2 years back.

POWER TRAIN

Transmission control module.

SUSPENSION

Drivers side lower control arm failed at the lower ball joint mounting hole, allowing the ball joint to separate from the arm. All vehicle steering and control was lost due to the failure. This failure: 1. Has extreme danger for traffic fatalities. 2. Suggests substandard materials, design, or manufacturing. Control arm manufacturer: DLZ Sold by: partsgoing Vendor: Amazon.com

FUEL SYSTEM, DIESEL

2008 MAZDA 3. CONSUMER WRITES IN REGARDS TO DEFECTIVE FUEL PUMP.

STEERING

TL* THE CONTACT OWNS A 2008 MAZDA MAZDA3. THE CONTACT STATED THAT THE VEHICLE EXPERIENCED LOSS OF POWER STEERING ASSIST WHILE DRIVING AT VARIOUS SPEED AND MAKING TURN. THE POWER STEERING FAILED AND THE STEERING WHEEL BECAME DIFFICULT TO TURN. THE PARKING BRAKE AND POWER STEERING ASSIST WARNING LIGHTS WERE ILLUMINATED. THE CONTACT STATED THAT THE FAILURE OCCURRED FIVE TIMES IN TWO DAYS. THE CONTACT MENTIONED THAT AN UNKNOWN RECALL REPAIR WAS COMPLETED ON THE VEHICLE FOR THE POWER STEERING, HOWEVER THE REPAIR HAD NOT CORRECTED THE FAILURE. THE VEHICLE WAS NOT TAKEN TO A DEALER OR AN INDEPENDENT MECHANIC FOR DIAGNOSTIC TESTING. THE MANUFACTURER WAS MADE AWARE OF THE FAILURE AND INFORMED THE CONTACT THAT A RECALL REPAIR WAS COMPLETED FOR THE SAME FAILURE AND IT WAS A ONE-TIME FREE FIX AND PROVIDED A CASE NUMBER. THE FAILURE MILEAGE WAS APPROXIMATELY 90,000.

UNKNOWN OR OTHER,ENGINE

MY MAZDA3 DIES WHILE I AM DRIVING WITHOUT ANY INDICATION OF WHAT IS GOING ON (NO CHECK ENGINE LIGHT). WHEN IT DOES, I WAIT FOR A WHILE AND IT WILL START BACK UP AGAIN! MY SHOP AND I HAVE TRIED EVERYTHING WE CAN, BUT WE CAN'T FIGURE OUT WHY IT IS DOING THAT! I CALLED THE MANUFACTURE AND THEY SAID IT WAS RECALLED FOR POWER STEERING ASSIST FAILURE AND FIXED IN 2010 BUT TO US IT SOUNDS IT IS THAT ISSUE CAUSING IT TO STOP WHILE IN MOTION! THIS CAR IS UNSAFE!! NO CAR SHOULD STOP IN MOTION FROM NOWHERE! THE MANUFACTURE SHOULD BE RESPONSIBLE FOR THAT!

STEERING,AIR BAGS,SERVICE BRAKES

AIRBAG LIGHT IS ON.....LOST POWER STEERING AT ONLY 110,000 MILES...ABS BREAK SYSTEM NOT WORKING

POWER TRAIN

AT AND YELLOW CHECK ENGINE LIGHT CAME ON AND CAR WAS IN LIMP MODE FIRST THING IN MORNING AFTER HAVING NO ISSUES WITH MY MAZDA PREVIOUSLY. CODES CAME BACK WITH SOLENOIDS A, B, C, D, E ALL HAVE ELECTRICAL FAILURE, AND ISSUES WITH THE OXYGEN SENSOR. MY CAR HAS HAD REGULAR MAINTENANCE DONE ON IT. NO SIGNS OR SYMPTOMS OF TRANSMISSION FAILURE BEFOREHAND. HAPPENED INSTANTLY OVERNIGHT. TCM IS NOT IN STOCK ANYWHERE AND I SUSPECT THAT IS THE CULPRIT DUE TO OTHER MAZDA OWNERS SIMILAR SITUATIONS. 95K MILES.

SERVICE BRAKES

BRAKES BECAME SPONGY AFTER HARD BRAKING AT INTERSTATE HIGHWAY SPEED OF 65 MPH. AFTERWARD, SPORADICALLY, BRAKES WOULD REQUIRE SEVERAL PUMPS OF THE PEDAL TO BUILD ENOUGH HYDRAULIC PRESSURE TO STOP THE VEHICLE. I'M REPORTING THIS INCIDENT NOW AFTER LEARNING ABOUT FORD RECALL 19S54, NHTSA IDENTIFIER 19V904. BRAKE PARTS ON THIS CAR WERE MADE BY FOMOCO. ABS HYDRAULIC UNIT, P/N BVSN-43-7AZD, WAS REPLACED BY MAZDA DEALER TO CORRECT PROBLEM AT A COST OF $1200.