2010 Mazda Mazda6

2010 Mazda6 4-DR. w/SAB

Overall

Not Rated

Front Crash

Not Rated

Side Crash

Not Rated

Rollover

Not Rated

AIR BAGS:FRONTAL:PASSENGER SIDE:INFLATOR MODULE

Mazda North American Operations (Mazda) is recalling certain 2014-2015 Mazda CX-9 vehicles sold, or ever registered in the states of Alabama, California, Florida, Georgia, Hawaii, Louisiana, Mississippi, South Carolina, Texas, Puerto Rico, American Samoa, Guam, the Northern Mariana Islands (Saipan), and the U.S. Virgin Islands or "Zone A." Additionally, unless covered in "Zone A," Mazda is recalling certain 2011-2013 Mazda6, 2011-2012 CX-7, and 2011-2015 CX-9 sold, or ever registered in the states of Arizona, Arkansas, Delaware, Illinois, Indiana, Kansas, Kentucky, Maryland, Missouri, Nebraska, Nevada, New Jersey, New Mexico, North Carolina, Ohio, Oklahoma, Pennsylvania, Tennessee, Virginia, West Virginia and the District of Columbia, or "Zone B." Additionally, unless covered in Zone A or Zone B, Mazda is recalling certain 2010-2013 Mazda6, 2010-2012 CX-7, and 2010-2015 CX-9 vehicles ever registered in the states of Alaska, Colorado, Connecticut, Idaho, Iowa, Maine, Massachusetts, Michigan, Minnesota, Montana, New Hampshire, New York, North Dakota, Oregon, Rhode Island, South Dakota, Utah, Vermont, Washington, Wisconsin, and Wyoming or "Zone C." These vehicles are equipped with certain air bag inflators assembled as part of the passenger frontal air bag modules used as original equipment or replacement equipment. In the event of a crash necessitating deployment of the passenger frontal air bag, these inflators may explode due to propellant degradation occurring after long-term exposure to absolute humidity and temperature cycling.

Campaign: 18V717000

SUSPENSION:FRONT:CONTROL ARM

Mazda North American Operations (Mazda) is recalling certain 2009-2010 Mazda Mazda6 vehicles sold, or ever registered in Connecticut, Delaware, Illinois, Indiana, Iowa, Kentucky, Maine, Maryland, Massachusetts, Michigan, Minnesota, Missouri, New Hampshire, New Jersey, New York, Ohio, Pennsylvania, Rhode Island, Vermont, Virginia, West Virginia, Wisconsin and the District of Columbia. The front cross member may corrode after exposure to road salt.

Campaign: 18V631000

AIR BAGS:FRONTAL:PASSENGER SIDE:INFLATOR MODULE

Mazda North American Operations (Mazda) is recalling certain 2007-2012 CX-7, CX-9, and 2009-2012 Maza6 vehicles. These vehicles had their passenger frontal air bag inflators previously replaced under a prior recall using inflators of the same design. The inflators may explode due to propellant degradation occurring after long-term exposure to high absolute humidity, temperature and temperature cycling.

Campaign: 19V782000

AIR BAGS:FRONTAL:PASSENGER SIDE:INFLATOR MODULE

Mazda North America Operations (Mazda) is recalling certain 2009-2011 Mazda6, and 2007-2011 CX-7 and CX-9 vehicles. These vehicles are equipped with certain air bag inflators assembled as part of the passenger frontal air bag modules, and used as original equipment or replacement equipment. In the event of a crash necessitating deployment of the front air bags, these inflators may rupture due to propellant degradation occurring after long-term exposure to absolute humidity and temperature cycling.

Campaign: 17V429000

AIR BAGS:FRONTAL:PASSENGER SIDE:INFLATOR MODULE

Mazda North American Operations (Mazda) is recalling certain 2013 Mazda6 and CX-9 vehicles sold, or ever registered in the states of Alabama, California, Florida, Georgia, Hawaii, Louisiana, Mississippi, South Carolina, Texas, Puerto Rico, American Samoa, Guam, the Northern Mariana Islands (Saipan), and the U.S. Virgin Islands or "Zone A." Additionally, unless covered in "Zone A," Mazda is recalling certain 2010 Mazda6, CX-7 and CX-9 vehicles sold, or ever registered in the states of Arizona, Arkansas, Delaware, District of Columbia, Illinois, Indiana, Kansas, Kentucky, Maryland, Missouri, Nebraska, Nevada, New Jersey, New Mexico, North Carolina, Ohio, Oklahoma, Pennsylvania, Tennessee, Virginia, and West Virginia or "Zone B." Additionally, unless covered in Zone A or Zone B, Mazda is recalling certain 2009 Mazda6, CX-7, and CX-9 vehicles ever registered in the states of Alaska, Colorado, Connecticut, Idaho, Iowa, Maine, Massachusetts, Michigan, Minnesota, Montana, New Hampshire, New York, North Dakota, Oregon, Rhode Island, South Dakota, Utah, Vermont, Washington, Wisconsin, and Wyoming or "Zone C." These vehicles are equipped with certain air bag inflators assembled as part of the passenger frontal air bag modules used as original equipment or replacement equipment. In the event of a crash necessitating deployment of the passenger frontal air bag, these inflators may explode due to propellant degradation occurring after long-term exposure to absolute humidity and temperature cycling.

Campaign: 18V018000

AIR BAGS:FRONTAL:SENSOR/CONTROL MODULE-INACTIVE

Mazda North American Operations (Mazda) is recalling certain model year 2009-2010 Mazda6 vehicles manufactured February 4, 2008, to December 3, 2009. The protective coating may not have been properly applied to the air bag control unit (ACU) and, as a result, moisture may damage the unit causing it to malfunction.

Campaign: 16V594000

FUEL SYSTEM, GASOLINE

Mazda North America Operations (Mazda) is recalling certain model year 2010-2012 Mazda6 vehicles manufactured September 14, 2009, through May 2, 2011, and equipped with 2.5L engine. In the affected vehicles, spiders may weave a web in the evaporative canister vent hose, blocking it and causing the fuel tank to have an excessive amount of negative pressure.

Campaign: 14V114000

LATCHES/LOCKS/LINKAGES:DOORS:LATCH

Mazda is recalling certain model year 2009-2013 Mazda6 vehicles manufactured February 4, 2008, through August 24, 2012. The door latch mounting screws may become loose.

Campaign: 13V425000

FUEL SYSTEM, GASOLINE:STORAGE:TANK ASSEMBLY

MAZDA IS RECALLING CERTAIN MODEL YEAR 2009-2010 MAZDA6 VEHICLES MANUFACTURED FROM APRIL 8, 2008, THROUGH FEBRUARY 8, 2010. A CERTAIN TYPE OF SPIDER MAY WEAVE A WEB IN THE EVAPORATIVE CANISTER VENT LINE AND THIS MAY CAUSE A RESTRICTION IN THE LINE. IF THIS OCCURS, THE FUEL TANK PRESSURE MAY BECOME EXCESSIVELY NEGATIVE WHEN THE EMISSION CONTROL SYSTEM WORKS TO PURGE THE VAPORS FROM THE CANISTER.

Campaign: 11V134000

SUSPENSION

I recently had my front subframe replaced as part of your recall, however, the rear subframe and all components attached are suffering from the exact same rust and potential component failure as the front. I was replacing my brakes today and noticed that the entire structure is on the verge of complete failure. The right rear suspension already makes unusual noises when going over even small bumps and I imagine if I were to hit a large pothole that would probably be the end of this car. I imagine all similar Mazda 6s in the Midwest suffer from the exact same degradation and it is a major safety concern. There are places where there's chunks of subframe missing because it has rusted completely through and just disintegrated.

SUSPENSION,UNKNOWN OR OTHER

I looked up recalls on my vehicle and it states that The 2011 Mazda6 is  part of a recall (NHTSA 19V-323, Mazda 2818I) covering 2011-2013 models for front cross member (subframe) corrosion due to insufficient rust protection . In salt-belt states, this corrosion can cause the lower control arm to detach, reducing steering control and increasing crash risk.  Key Details regarding the 2011 Mazda6 Subframe Recall: Scope: The recall affects specific 2011-2013 Mazda6 vehicles (and 2009-2010 models in a previous, related recall). Location Restrictions: Vehicles must have been originally sold in, or currently/previously registered in, 23 "salt belt" states (including CT, NY, MI, MN, OH, etc.). The Issue: The front cross member may experience severe corrosion, causing structural failure of the passenger-side lower control arm mounting point. Symptoms: Drivers may notice a change in steering alignment or a broken cross member. Remedy: Dealers will inspect the cross member and replace it if necessary. Action Required: Owners should contact their local Mazda dealership to check their VIN for open recalls.  The recall was officially announced in May 2019 and is an expansion of a 2018 action. 

STEERING,STRUCTURE

The contact owns a 2010 Mazda Mazda6. The contact stated that while driving at an undisclosed speed, the vehicle inadvertently veered to the left. There was no warning light illuminated. The contact stated that the vehicle became difficult to steer. The vehicle was taken to an independent mechanic where it was diagnosed and determined that the engine cradle had failed and was severely rusted and needed to be replaced. The vehicle was not repaired. The dealer was contacted; however, the vehicle was not diagnosed or repaired. The manufacturer was made aware of the failure. The approximate failure mileage was 114,000.

AIR BAGS

The airbag light is still flashing on the dashboard after the airbag recall on this vehicle was fixed. It may be related to a different recall, which is safety campaign #16V594000.

SUSPENSION

Extensive rust and corrosion in rear subframe. So severe the vehicle is unsafe to drive.

SUSPENSION

2010 mazda 6 i series sedan the entire rear subframe/cradle is rotted along with all the other parts connected to it, the A arm, bumper stops, control arms, rear sway bar the entire rear under carriage. took it to the shop and they said there have been several complaints about this exact issue on several of these cars from 09-13 models. the parts was not painted correctly like the front that was recalled. exposed to all weather elements, the shop wants almost 4k for labor only to fix but the main problem is finding the rear subframe on these cars is almost impossible next to cost a fortune. now i have a yard ornament. junk yard wants to give me 170 bucks for the car but im not doing that. Mazda needs to fix this issue. i would of never know it was rotted out unless i took it to the shop for rear swaying and sagging. its all over the road. very dangerous and will cause a wreck almost certainly. please someone do something about this issue. dont have the money to fix this let alone buy another car.

SUSPENSION

The rear subframe is compromised; it separated from the body of the car. The vehicle is in my driveway and available for inspection should the need arise. The rear end had felt a bit shaky for a month so I took it to my mechanic, who declared the vehicle "unfit for the road" due to the fact that the subframe was rotted away and detached from the car itself. I was told one big bump is an accident waiting to happen...pieces of the car would go flying and I could be left with zero mobility to evade oncoming traffic. The possibility of projectiles injuring anyone around the car was enough for me to park it. The car has not been inspected by Mazda, the police, or insurance because there was no accident. Since it's not safe to drive, I took the word of my independent mechanic rather than driving it to a dealership. There were no warnings other than a bit of a sway in the rear end, which I originally attributed to its age. I've researched the issue and it seems to be a result of subpar quality with regard to the metal that was used in manufacturing.

STRUCTURE

The contact owns a 2010 Mazda Mazda6. The contact stated while driving 40–45 MPH, there was an abnormal sound coming from the vehicle. The TPMS warning light was illuminated. The vehicle was taken to an independent mechanic, who informed the contact that the rear main sub frame was completely rusted. There was a crack detected in the middle of the sub frame. The vehicle was taken to the local dealer, where it was diagnosed that the rear sub frame was rusted and needed to be replaced. The vehicle was not repaired. The manufacturer informed the contact that it was normal wear and tear, but no assistance was provided. The failure mileage was approximately 130,000.

SUSPENSION

Rear sub frame on car rusting out. Never protected from corrosion or rust. Car is currently in shop. Car has rusted out in the joint just behind drivers rear tire. Received notice of recall on the front of car due to salt and weather conditions front sub frame area replaced . Currently multiple cars have same issues Mazda hasnt fixed or issued any repairs for this

SUSPENSION

My gf went for a basic oil change and the automotive person was shocked to find the rear right cross bar to be suffering from incredible corrosion. He said at this point it is unsafe to drive. We looked into recalls for this make and model and there is one for the front cross bar due to insufficient or improper application of a corrosion spray on the frame. How can they say the front needs to be recalled and not the back? If the dealership didn’t do a good job of covering the appropriate metal frame in corrosion resistant spray any car that has that level should be recalled. This is immensely dangerous