2012 Mazda Mazda6

2012 Mazda Mazda6 4 DR FWD

Overall

★★★★☆

Front Crash

★★★☆☆

Side Crash

★★★★☆

Rollover

★★★★★

AIR BAGS:FRONTAL:PASSENGER SIDE:INFLATOR MODULE

Mazda North American Operations (Mazda) is recalling certain 2014-2015 Mazda CX-9 vehicles sold, or ever registered in the states of Alabama, California, Florida, Georgia, Hawaii, Louisiana, Mississippi, South Carolina, Texas, Puerto Rico, American Samoa, Guam, the Northern Mariana Islands (Saipan), and the U.S. Virgin Islands or "Zone A." Additionally, unless covered in "Zone A," Mazda is recalling certain 2011-2013 Mazda6, 2011-2012 CX-7, and 2011-2015 CX-9 sold, or ever registered in the states of Arizona, Arkansas, Delaware, Illinois, Indiana, Kansas, Kentucky, Maryland, Missouri, Nebraska, Nevada, New Jersey, New Mexico, North Carolina, Ohio, Oklahoma, Pennsylvania, Tennessee, Virginia, West Virginia and the District of Columbia, or "Zone B." Additionally, unless covered in Zone A or Zone B, Mazda is recalling certain 2010-2013 Mazda6, 2010-2012 CX-7, and 2010-2015 CX-9 vehicles ever registered in the states of Alaska, Colorado, Connecticut, Idaho, Iowa, Maine, Massachusetts, Michigan, Minnesota, Montana, New Hampshire, New York, North Dakota, Oregon, Rhode Island, South Dakota, Utah, Vermont, Washington, Wisconsin, and Wyoming or "Zone C." These vehicles are equipped with certain air bag inflators assembled as part of the passenger frontal air bag modules used as original equipment or replacement equipment. In the event of a crash necessitating deployment of the passenger frontal air bag, these inflators may explode due to propellant degradation occurring after long-term exposure to absolute humidity and temperature cycling.

Campaign: 18V717000

AIR BAGS:FRONTAL:PASSENGER SIDE:INFLATOR MODULE

Mazda North American Operations (Mazda) is recalling certain 2007-2012 CX-7, CX-9, and 2009-2012 Maza6 vehicles. These vehicles had their passenger frontal air bag inflators previously replaced under a prior recall using inflators of the same design. The inflators may explode due to propellant degradation occurring after long-term exposure to high absolute humidity, temperature and temperature cycling.

Campaign: 19V782000

STRUCTURE

Mazda North American Operations (Mazda) is recalling certain 2011-2013 Mazda6 vehicles sold, or ever registered in Connecticut, Delaware, the District of Columbia, Illinois, Indiana, Iowa, Kentucky, Maine, Maryland,Massachusetts, Michigan, Minnesota, Missouri, New Hampshire, New Jersey, New York, Ohio, Pennsylvania, Rhode Island, Vermont, Virginia, West Virginia, and Wisconsin. The front cross member may corrode after exposure to road salt.

Campaign: 19V323000

AIR BAGS:FRONTAL:PASSENGER SIDE:INFLATOR MODULE

Mazda North America Operations (Mazda) is recalling certain 2012 CX-7, CX-9 and Mazda6 vehicles sold, or ever registered, in the states of Alabama, California, Florida, Georgia, Hawaii, Louisiana, Mississippi, South Carolina, Texas, Puerto Rico, American Samoa, Guam, the Northern Mariana Islands (Saipan), and the U.S. Virgin Islands, or "Zone A." Additionally, unless included in "Zone A" above, Mazda is recalling certain 2009 CX-7, CX-9 and Mazda6 vehicles sold, or ever registered in the states of Arizona, Arkansas, Delaware, District of Columbia, Illinois, Indiana, Kansas, Kentucky, Maryland, Missouri, Nebraska, Nevada, New Jersey, New Mexico, North Carolina, Ohio, Oklahoma, Pennsylvania, Tennessee, Virginia, and West Virginia, or "Zone B." Additionally, unless included in "Zone A" or "Zone B" above, Mazda is recalling certain 2007-2008 CX-7 and CX-9 sold, or ever registered in the states of Alaska, Colorado, Connecticut, Idaho, Iowa, Maine, Massachusetts, Michigan, Minnesota, Montana, New Hampshire, New York, North Dakota, Oregon, Rhode Island, South Dakota, Utah, Vermont, Washington, Wisconsin, and Wyoming. These vehicles are equipped with certain air bag inflators assembled as part of the passenger frontal air bag modules used as original equipment or replacement equipment. In the event of a crash necessitating deployment of the passenger frontal air bag, these inflators may rupture due to propellant degradation occurring after long-term exposure to absolute humidity and temperature cycling.

Campaign: 17V457000

FUEL SYSTEM, GASOLINE

Mazda North America Operations (Mazda) is recalling certain model year 2010-2012 Mazda6 vehicles manufactured September 14, 2009, through May 2, 2011, and equipped with 2.5L engine. In the affected vehicles, spiders may weave a web in the evaporative canister vent hose, blocking it and causing the fuel tank to have an excessive amount of negative pressure.

Campaign: 14V114000

LATCHES/LOCKS/LINKAGES:DOORS:LATCH

Mazda is recalling certain model year 2009-2013 Mazda6 vehicles manufactured February 4, 2008, through August 24, 2012. The door latch mounting screws may become loose.

Campaign: 13V425000

UNKNOWN OR OTHER

Passenger dash has cracked some and dash is very very sticky..why has this happened..I feel if airbag had to deploy it would not because of this situation

SUSPENSION,UNKNOWN OR OTHER

The rear subframe and suspension parts are rusted so bad that the car is not safe to drive. Looked up recalls and found out the front subframe had a recall and was taken care of before I bought the car. Also found recall for my model of car that were registered in state that use salt on there roads which is one of the state i live in. Was told my Mazda corporation the only certain 2012 mazda vehicle's vehicle's were covered for rusting issues with the rear . If the front of the car is recalled and the same problem happens with the rear of the car shouldn't it be covered for something? I have an appointment coming up on the 21 of January which is ridiculous that I have to wait 3 weeks to have it looked at. . Thank you for your time. The only reason I found the problem with the car was a stick got stuck in the rusted out parts and when I took it out a bunch of rust fell on the ground.

SUSPENSION,STRUCTURE

The contact owns a 2012 Mazda Mazda6. The contact stated while driving 55 MPH and crossing a bridge, the vehicle stopped unexpectedly after driving over several expansion joints. The contact stated that the vehicle had not stalled. The contact exited the vehicle and noticed that the passenger’s side front wheel was slanted into the wheel well. The contact inspected the wheel well and noticed that the control arm had sheared off at the cross member. The contact stated that prior to the failure, the steering wheel had turned slightly to the right. The contact researched online and related the failure to NHTSA Campaign Number: 19V323000 (Structure, Suspension), which included the VIN. The contact stated that the vehicle was towed to a dealer, where the contact was advised that the VIN was included in a recall, and the contact was advised that the vehicle needed to be diagnosed to determine the cause of the failure. The contact stated that the dealer had not diagnosed vehicle in a month. The manufacturer was informed of the failure and advised the contact to work with the dealer. The vehicle was not diagnosed or repaired. The contact stated that the manufacturer and dealer had exceeded a reasonable amount of time for the recall repair. The failure mileage was approximately 188,000.

SUSPENSION,STRUCTURE

The contact owns a 2012 Mazda Mazda6. The contact stated while driving 55 MPH, the steering wheel began to shake violently, with the low tire pressure warning light illuminated. The contact pulled over to inspect the vehicle and discovered that the front passenger’s side tire had detached from the vehicle. The contact's father was called to the scene and the spare tire was placed on the vehicle. The contact then drove to an independent mechanic where both the front driver’s and front passenger’s side tires were replaced. The manufacturer was notified of the failure and referred the contact to the dealer for assistance. The vehicle was taken to the dealer where a diagnostic test was performed; and the diagnostic test determined that the cross member had corroded and caused the tire failure. The contact was then notified that the vehicle was not covered under NHTSA Campaign Number: 19V323000 (Structure, Suspension) and that the warranty on the vehicle had expired. The vehicle remained in the possession of the dealer and was not repaired. The failure mileage was 204,000.

SUSPENSION

Front subframe completely rusted out causing loss of steering. I believe this should have been covered by Safety Recall 2818I which addresses the issue. Mazda inspected and said because the recall was performed in 2019 on this car, there is nothing more they can do, once and done. Unfortunately their fix didn't take care of the issue.

STRUCTURE

My 2012 mazda 6 Subframe is is unsafe to drive due to over-time corrosion My local mechanics said Madzda Corp. should fix it.

SUSPENSION

Rear sub frame, critical fail- rusted through. Needs new rear subframe. Wheel pulling to right, unable to align. I bought this car 2 weeks ago for my 16 year old daughter and was told today it needs to be scrapped. She is devastated . We are out 4500 with no recourse. I bought a Mazda because I trusted the safety. I am so disappointed. If the front was recalled the rear should have been too.

UNKNOWN OR OTHER

THE REAR SUBFRAME IS RUSTED IN LAYERS AND IS SPALLING OFF.

AIR BAGS,UNKNOWN OR OTHER

The passenger dash board is melting. It covers the passengers air bag. I would like to know if a recall is still possible for my vehicle. I understand that there was a recall in 2015-2017, but unfortunately I did not received the notice since I was moving from Illinois to Kansas and later to Texas and continued changing addresses during that time frame.

SUSPENSION

Severe rusting of the rear frame and suspension