2005 Mazda Tribute

2005 Mazda Tribute (Later Release) 4-DR.

Overall

Not Rated

Front Crash

Not Rated

Side Crash

Not Rated

Rollover

Not Rated

2005 Mazda Tribute (Early Release) 4-DR.

Overall

Not Rated

Front Crash

Not Rated

Side Crash

Not Rated

Rollover

★★★☆☆

SUSPENSION:FRONT:WHEEL BEARING

The Timken Company (Timken) is recalling certain aftermarket front wheel bearings, part number 510072, sold from January 22, 2015, to May 21, 2015, to be used as service parts on 2001-2012 Ford Escape, 2001-2011 Mazda Tribute, and 2005-2011 Mercury Mariner vehicles. The affected wheel bearings have incorrect dimensions of a 42mm bore, 76mm outer dimension, and 39mm width, instead of a 42mm bore, 78mm outer dimension and a 45mm width.

Campaign: 15E045000

ENGINE AND ENGINE COOLING

Mazda is recalling certain model year 2001 through 2006, and 2008, Tribute vehicles equipped with 3.0L V6 engines and speed control. Inadequate clearance between the engine cover and the speed control cable connector could result in a stuck throttle when the accelerator pedal is fully or almost-fully depressed. This risk exists regardless of whether or not speed control (cruise control) is used.

Campaign: 12V357000

SEATS:FRONT ASSEMBLY:HEAD RESTRAINT

CERTAIN SPORT UTILITY VEHICLES EQUIPPED WITHOUT SIDE AIR CURTAINS OR MOON ROOFS FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 201, "OCCUPANT PROTECTION IN INTERIOR IMPACT." DURING TESTING, THE FREE MOTION HEAD FORM REGISTERED A MEASUREMENT ABOVE THE PERMITTED LIMIT AT THE LEFT HAND A-PILLAR TRIM AREA.

Campaign: 06V116000

LATCHES/LOCKS/LINKAGES:HATCHBACK/LIFTGATE:LOCK

CERTAIN 2004-2005 SPORT UTILITY VEHICLES AND CERTAIN 2001-2003 SPORT UTILITY VEHICLE HAVING REAR LIFTGATE COMPONENTS SERVICED WITH 2004 EQUIVALENT COMPONENTS FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 206, 'DOOR LOCKS AND DOOR RETENTION COMPONENTS.' THE REAR LIFTGATE LATCHING SYSTEM DOES NOT MEET THE INERTIA LOAD REQUIREMENT IN ONE DIRECTION.

Campaign: 04V605000

SUSPENSION,STRUCTURE

Passenger rear shock mount toatly rusted through. A big hole!

SUSPENSION

Rear passenger shock mount rusted out completely

STRUCTURE

The rear wheel well was completely rusted out while the other side is fine. The shock broke loose causing the vehicle to drop down. I have a 17 year old that is not an experienced driver and this could have resulted in her getting seriously hurt. From what I read they recalled the vehicle to to 2004 and I don’t understand why they did not recall this one. They should have and this is a serious safety issue. Does someone have to die before they see that this needs to be fixed?

STRUCTURE

owned since day one, bought brand new, religiously maintained, perfect shape other than completely rusted wheel house back left passenger side. Shock went through rusted area all the way to trunk. Mazda recalled models 2003 to 2004 for this problem yet so many 2005 Mazda Tribute owners are having exact problem especially when manufactured in 2004! This is serious and I had my granddaughter with me when this happened and yet Mazda wants to do nothing about it when it’s a serious hazard and ongoing problem with the 2005’s. It is always the back passenger side with this problem! I have no money to purchase a car and now my lifeline to support my family is broke!

UNKNOWN OR OTHER

The passenger side rear wheel well has rusted out and the brake mount is deteriorating as well affecting the safety of the vehicle. I have been told that this is a common issue on Mazda Tribute and Ford Escape models for the years 2001-2005 by my mechanic as well as Mazda dealer reps. They stated the 2001-2004 models were recalled but not the 2005. However, t hey mentioned that these should likely have been recalled as well. One would think that if you take care of your car that the components of the frame should not rust out.

UNKNOWN OR OTHER

I have found several complaints on the 2005 Mazda Tribute with the rear wheel well rusting out. Mazda did a recall on the 2004 but not the 2005. I previously had to replace the rear wheel in 2018 and it now needs replaced again due to rusting. With the number of complaints I have read, along with the outrageous cost to repair, I do not understand why Mazda, nor the NHTSA have done anything about this. A recall NEEDS to be issued ASAP.

SUSPENSION

The wheel well rusted out, completely leaving the shock tower and stability of the car at risk, rusted out completely, I'm a light backyard mechanic and I've seen the Ford do the same . The repair is almost the value of the car, and unless you trust them your basically buying a new vehicle, because while you're there may change the set of shock's and absorber that's about 700. To include. This car had a rumor of being as good as the Everlasting Santa Fe, and Toyota 4runner. Vehicle is in pristine shape aside from the fatal rust.. recall recall recall recall

SUSPENSION,STRUCTURE,UNKNOWN OR OTHER

AS A PROBLEM WITH MANY OTHER MAZDA TRUBUTES, THE WHEEL WELL IS RUSTED THROUGH AND THE STRUT IS NO LONGER HELD IN PLACE, YET PROTRUDING INTO THE INTERIOR OF THE CAR. THIS HAS BEEN AN ISSUE THAT REQUIRED A RECALL FOR OTHER MAZDA TRIBUTES, BUT NOT THE 2005 VERSION. ACCORDING TO MANY FORUMS, THIS IS A PROBLEM WITH MANY OTHER 05 TRIBUTES.

STRUCTURE

RIGHT REAR SHOCK TOWER RUSTED OUT AND SHOCK BROKE THROUGH AND INTO THE PASSENGER COMPARTMENT. SEVER RUST ON RIGHT SIDE OF FRONT SUB FRAME AS WELL. I CAME ACROSS THIS PERFORMING GENERAL MAINTENANCE.

SUSPENSION,STRUCTURE,WHEELS

RIGHT REAR FRAME HAS RUSTED OUT ENOUGH TO CAUSE BRAKE AND SHOCK ISSUES CAUSING A PERFECTLY GOOD VEHICLE TO BECOME UNSAFE AND DANGEROUS FOR MY FAMILY AND OTHERS. THE SHOCK AND BRAKE LINE BROKE AND THE VEHICLE SLID TO A STOP.