2006 Mitsubishi Lancer

2006 Mitsubishi Lancer 4-DR.

Overall

Not Rated

Front Crash

Not Rated

Side Crash

Not Rated

Rollover

Not Rated

AIR BAGS:FRONTAL:PASSENGER SIDE:INFLATOR MODULE

Mitsubishi Motors North America, Inc. (Mitsubishi) is recalling certain 2004-2006 Lancer and Lancer Evolution vehicles and 2004 Lancer Sportback vehicles. These vehicles are equipped with a passenger side frontal air bag that may be susceptible to moisture intrusion which, over time, could cause the inflator to rupture.

Campaign: 17V569000

AIR BAGS:FRONTAL:PASSENGER SIDE:INFLATOR MODULE

Mitsubishi Motors North America, Inc. (MMNA) is recalling certain 2004-2006 Mitsubishi Lancer vehicles that previously received a like-for-like passenger side frontal air bag inflator under recall 15V321 as interim remedy. Also recalled are 2004-2006 Lancer vehicles located in Guam or Saipan that previously received or never received a new inflator under 15V321 or 17V569. These passenger side frontal air bag inflators may be susceptible to moisture intrusion which, over time, could cause the inflator to explode in the event of an air bag deployment.

Campaign: 18V220000

SUSPENSION:FRONT:CONTROL ARM:LOWER ARM

Mitsubishi Motors North America, Inc. (MMNA) is recalling certain model year 2002-2007 Lancer, 2004 Lancer Wagon, 2003-2006 Lancer Evolution, 2003-2006 Outlander and 2007-2013 Outlander V-6 vehicles originally sold in, or ever registered in, Connecticut, Delaware, Illinois, Indiana, Iowa, Kentucky, Maine, Maryland, Massachusetts, Michigan, Minnesota, Missouri, New Hampshire, New Jersey, New York, Ohio, Pennsylvania, Rhode Island, Vermont, Virginia, West Virginia, Wisconsin and the District of Columbia. In the affected vehicles, the front lower control arms may detach due to the front cross member corroding from salt water exposure such as from road salt use.

Campaign: 16V458000

AIR BAGS:FRONTAL:PASSENGER SIDE:INFLATOR MODULE

Mitsubishi Motors North America, Inc. (MMNA) is recalling certain model year 2006-2007 Lancer and Lancer Evolution vehicles manufactured June 29, 2005, to June 19, 2007, equipped with certain air bag inflators assembled as part of the passenger frontal air bag modules, and used as original equipment or replacement equipment. In the event of a crash necessitating air bag deployment, these inflators may rupture due to propellant degradation occurring after long-term exposure to absolute humidity and temperature cycling.

Campaign: 16V334000

EXTERIOR LIGHTING:HEADLIGHTS

DOPE, INC. IS RECALLING 42,540 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS.

Campaign: 09E025000

EXTERIOR LIGHTING:HEADLIGHTS

CERTAIN ANZO COMBINATION HEADLAMP ASSEMBLIES SOLD AS REPLACEMENT LAMPS FOR USE ON CERTAIN PASSENGER VEHICLES. SOME COMBINATION LAMPS ARE NOT EQUIPPED WITH AMBER SIDE REFLECTORS WHICH FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT."

Campaign: 06E023000

EXTERIOR LIGHTING

CERTAIN TRADESONIC COMBINATION LAMPS SOLD AS REPLACEMENT LAMPS FOR USE ON THE ABOVE LISTED PASSENGER VEHICLES. COMBINATION LAMPS NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT.

Campaign: 06E064000

SUSPENSION

The contact owns a 2006 Mitsubishi Lancer. The contact stated while driving from a complete stop, she heard abnormal loud grinding sounds coming from underneath the front passenger's side of the vehicle. The contact stated that the failure had been reoccurring increasingly while driving. Additionally, the contact stated that her mother had informed her that she had seen an unknown part hanging underneath the front passenger's side of the vehicle. The dealer was notified of the failure and informed the contact that she would need to take the vehicle to their location for recall repair under NHTSA Campaign Number: 16V458000 (Suspension). The vehicle was not diagnosed or repaired. The manufacturer was not notified of the failure. The failure mileage was approximately 164,550.

SUSPENSION

When doing routine repair on the control arms, it was noted that there is a ginormous rust hole in the subframe where the control arm connects to aforementioned subframe

STRUCTURE

My lancer has very bad rear end chassis rust where the rear subframe is fastened to the monobody. In this area all the suspension components and rear drivetrain are located. Damage occurs due to salt and other corrosive agents that are used for roads in Connecticut to melt snow. These agents rust the car where Mitsubishi failed to properly protect the steel under the rear end of the vehicle. It is widely observed that the 03-06 lancer has from factory a poor to almost no anti rust agent applied to the lower rear chassis area of the car where the subframe crossmember is located that holds suspension components and rear differential. Currently under nhtsa campaign 16V458000, there is a safety recall for the front subframe crossmember due to rust damage. As for the rear of the car there most certainly should be a safety campaign as the rust in this area develops quicker and can cause a catastrophic failure.

STRUCTURE

The contact owns a 2006 Mitsubishi Lancer. The contact stated while working on the vehicle, the contact noticed that there was a huge hole in the sub-frame due to rust. The contact stated no warning light was illuminated. The vehicle was taken to the local dealer and it was diagnosed that the sub-frame needed to be replaced. The vehicle was not repaired. The contact related the failure to an unknown recall. The manufacturer was not informed of the failure. The failure mileage was approximately 196,000. The VIN was unavailable.

STRUCTURE

REAR FRAME RAIL RUST. THE CAR STATED TO ACCUMULATE RUST ON THE FRAME RAILS OF THE CAR THAT CONNECTS THE REAR SUBFRAME AND REAR TOE ARM. FAILURE OF THESE AREAS COULD LEAD TO A CRASH. THE MANUFACTURER DID A POOR JOB CORROSION PROOFING THIS AREA ON THIS MODEL YEAR. THE CAR HAD A 7 YEAR/ 100,000 RUST WARRANTY IN WHICH I AM SURE THIS PROBLEM DEVELOPED WITHIN THAT COVERAGE BUT WAS HARD TO NOTICE UNTIL RUST STARTED FORMING ON THE OUTSIDE FRAME WHICH IS HARD TO SEE WITHOUT JACKING UP THE CAR. *TR

VISIBILITY/WIPER

TL* THE CONTACT OWNS A 2006 MITSUBISHI LANCER. THE CONTACT STATED THAT HE WAS UNABLE TO USE THE DEFROSTER, WHICH PREVENTED HIM FROM SEEING OUT THE WINDOW. THERE WERE NO WARNING INDICATORS ILLUMINATED. THE VEHICLE WAS TAKEN TO AUTO GALLERY MITSUBISHI-CORONA (LOCATED AT 2550 WARDLOW RD, CORONA, CA 92882, (951) 372-0008) WHERE IT WAS DIAGNOSED THAT THE TEMPERATURE CONTROL UNIT NEEDED TO BE REPLACED. THE VEHICLE WAS NOT REPAIRED. THE MANUFACTURER WAS NOT NOTIFIED. THE FAILURE MILEAGE WAS 143,000.

EXTERIOR LIGHTING,AIR BAGS,UNKNOWN OR OTHER

AFTER THEY CHANGE THE AIRBAGS FROM THE WARNING LIGHTS IS ON AND DEALERS CAN'T FIGURE OUT WHAT THE PROBLEM?

SUSPENSION,STRUCTURE

REAR CHASSIS MEMBER (A FRAME RAIL) CORRODED CLOSE TO THE POINT WHERE REAR SUBFRAME IS CONNECTED. IT IS NOW A SAFETY CONCERN TO DRIVE THE VEHICLE AS ANY SIGNIFICANT IMPACT MAY CAUSE THE REAR SUSPENSION TO DETACH. THERE WAS ALREADY A RECALL ON RUST OF THE FRONT SUBFRAME HOWEVER IT SEEMS THAT THE PROBLEM IS IN INADEQUATE UNDERCARRIAGE PROTECTION

SUSPENSION,STRUCTURE

REAR FRAME RAILS RUST CLOSE TO POINTS WHERE THE REAR SUBFRAME IS BOLTED ON. INSUFFICIENT SEALANT/COATING CAUSES RUST DAMAGE THAT CAN LEAD TO STRUCTURAL WEAKNESS.

AIR BAGS

DRIVER AIR BAG THE BOARD LIGHT WENT ON, ABOUT 10 MONTHS, WITH NO REASON WHEN I WAS DRIVING ON THE HIGHWAY