2013 Nissan 370z

2013 Nissan 370Z 2 DR RWD

Overall

Not Rated

Front Crash

Not Rated

Side Crash

Not Rated

Rollover

Not Rated

POWER TRAIN

THE CLUTCH SLAVE CYLINDER FAILED WHICH RESULTS IN NOT BEING ABLE TO PUT THE CAR IN GEAR ONCE YOU HAVE STOPPED AND PLACED THE CAR IN NEUTRAL. THIS FAILURE HAPPENED AT AN INTERSECTION AND CAUSED ME TO NOT BE ABLE TO PROCEED. ONE CAR ALMOST SLAMMED INTO ME. NISSAN HAS KNOWN ABOUT THIS INFERIOR PLASTIC PART SINCE 2009 AND HAS NOT CHANGED ANYTHING.

SERVICE BRAKES

WHEN BRAKING SUDDENLY THEY CAR GOES INTO "ICE MODE" WHERE IN THE BRAKE PEDAL IS HARD AND STOPPING POWER IS LIMITED.

ENGINE

IN MOTION, CAR WOULD NOT ACCELERATE ABOVE 2500RPM SUDDENLY. SPROCKET WAS DEFECTIVE. DEALER/ MANUFACTURER KNOWS THIS IS A PROBLEM, WONT FIX OR COVER UNDER WARRANTY.

POWER TRAIN

THE CLUTCH SLAVE CYLINDER FAILED ON OUR 370Z AS THE VEHICLE WAS DRIVING ON THE HIGHWAY AND COUNTY ROADS. THE CLUTCH PEDAL WOULD NOT RETURN ALL THE WAY BACK UP THUS CAUSING THE TRANSMISSION TO BE STUCK IN THE GEAR IT WAS IN, AND BE LESS IN CONTROL OF THE VEHICLE. AFTER DOING MORE RESEARCH SINCE, THIS IS A KNOWN PROBLEM WITH THE NISSAN 370Z DUE TO THE POOR DESIGN OF USING A PLASTIC CONSTRUCTED SLAVE CYLINDER THAT IS MOUNTED IN THE TRANSMISSION BELL HOUSING. THIS IS SOMETHING THAT NISSAN SHOULD HAVE RECALLED BY THIS POINT!

POWER TRAIN

WAS DRIVING DOWN THE HIGHWAY WHEN I WENT TO SHIFT INTO ANOTHER GEAR. THE PEDAL FELT "LIGHT", MEANING IT HAD LESS RESISTANCE IN THE FIRST HALF OF THE STROKE. IN THE REMAINING HALF OF THE STROKE THE CLUTCH DISENGAGED ENOUGH TO SHIFT GEARS. WHEN RELEASING THE CLUTCH PEDAL, IT REMAINED STUCK TO THE FLOOR AND I HAD TO FLIP IT TO ITS RELEASED POSITION WITH MY FOOT. THIS BEHAVIOR CONTINUED UNTIL I HAD THE CAR TOWED TO A SERVICE CENTER

AIR BAGS

THE AIR BAG DISABLED LIGHT IS ON WHEN MY WIFE SITS IN THE PASSENGER SEAT. SHE WEIGHS 120LBS AND IS 5' 8" TALL. I HAVE TAKEN THE CAR TO NISSAN SEVERAL TIMES AND THEY SAY THE SENSOR IS WORKING TO SPEC.

POWER TRAIN

HAD NO PRESSURE IN CLUTCH ABOUT A YEAR AGO WHILE DRIVING ON THE HIGHWAY AND KEPT GETTING STUCK AFTER RELEASING IT. HAD THE CLUTCH AND FLYWHEEL REPLACED, PROBLEM WENT AWAY FOR A WHILE. BUT IT'S BEEN LESS THAN A YEAR, AND I AM HAVING THE SAME PROBLEM AGAIN. I WAS DRIVING ON THE FREEWAY IN STOP AND GO TRAFFIC, AND THE CLUTCH SUDDENLY HAD NO PRESSURE HALFWAY AGAIN. NOW THE PROBLEM MIGHT BE THE CLUTCH MASTER CYLINDER OR CLUTCH SLAVE CYLINDER. IT HAPPENED SUDDENLY ON THE FREEWAY WITH NO INDICATION OF WARNING. I STILL HAVE STOCK POWER TERRAIN PARTS. I HAVE SEEN MANY PEOPLE ON 370Z FORUM WITH THE SAME EXACT PROBLEM.

POWER TRAIN,SERVICE BRAKES

CLUTCH PEDAL TO THE FLOORBOARD NO PRESSURE CAN'T DRIVE CAR CSC FAILURE INSIDE TRANSMISSION

ELECTRICAL SYSTEM,ENGINE

TL* THE CONTACT OWNS A 2013 NISSAN 370Z. THE CONTACT EXPERIENCED ISSUES STARTING THE VEHICLE WHILE DEPRESSING THE ENGINE START BUTTON. A WARNING INDICATOR ILLUMINATED ON THE KEY, WHICH MEANT AN INTELLIGENT KEY SYSTEM OR ELECTRICAL STEERING LOCK SYSTEM MALFUNCTION PER THE OWNER'S MANUAL. THE FAILURE OCCURRED ON MORE THAN ONE OCCASION. THE VEHICLE WAS NOT DIAGNOSED OR REPAIRED. THE MANUFACTURER WAS NOT MADE AWARE OF THE ISSUE. THE FAILURE MILEAGE AND VIN WERE UNKNOWN. *TR

POWER TRAIN

CAR HAS 17,751 MILES ON IT. BOUGHT 30 DAYS AGO FROM ACURA DEALER IN FORT WORTH. WENT TO PULL OUT OF GARAGE, AND THE CLUTCH PEDAL IS STUCK TO THE FLOOR. GETTING IT DIAGNOSED AT NISSAN DEALER, BUT IT'S BELIEVED TO BE A SLAVE CYLINDER THAT IS A KNOWN MALFUNCTION BY NISSAN, AND THEY WILL NOT RECALL IT OR COVER IT UNDER POWER-TRAIN WARRANTY.