2005 Toyota Sequoia

2005 Toyota Sequoia 4-DR

Overall

Not Rated

Front Crash

Not Rated

Side Crash

Not Rated

Rollover

Not Rated

AIR BAGS:FRONTAL:PASSENGER SIDE:INFLATOR MODULE

Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2010-2016 4Runner, 2003-2006 Tundra, 2003-2013 Corolla, 2009-2010 Corolla Matrix, 2004-2005 RAV4, 2002-2007 Sequoia, 2011-2013 Sienna, 2008-2012 Scion xB, 2008-2009 Lexus IS-F, 2007-2012 Yaris and Lexus ES350, 2010-2017 Lexus GX460, 2002-2010 Lexus SC430, 2006-2012 Lexus IS250 and IS350 and 2010-2015 Lexus IS250C and IS350C vehicles. These vehicles had their driver or passenger frontal air bag inflators previously replaced under a prior recall using inflators of the same design. The inflators may explode due to propellant degradation occurring after long-term exposure to high absolute humidity, temperature and temperature cycling.

Campaign: 19V741000

AIR BAGS:FRONTAL:PASSENGER SIDE:INFLATOR MODULE

Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2002-2005 Lexus SC and Toyota Sequoia, 2003-2005 Toyota Corolla and Tundra, and 2003-2007 Pontiac Vibe vehicles. These vehicles are equipped with certain air bag inflators assembled as part of the passenger frontal air bag modules used as original equipment or replacement equipment. In the event of a crash necessitating deployment of the passenger frontal air bag, these inflators may explode due to propellant degradation.

Campaign: 18V883000

SUSPENSION:FRONT:CONTROL ARM:LOWER BALL JOINT

Tenneco Automotive (DRiV) is recalling certain aftermarket ball joints for 2004-2007 Toyota Sequoia and 2004-2006 Toyota Tundra vehicles, MOOG part number K80521, K80522, NAPA part number NCP2601633, NCP2601634, ACDelco part number 45D2344, and 45D2345. The ball joint housing may have inadequate hardness, causing premature failure.

Campaign: 22E002000

SEATS:FRONT ASSEMBLY:SEAT HEATER/COOLER

Southeast Toyota Distributors, LLC (SET) is recalling certain model year 2010-2011 Prius and Corolla, 2009-2011 Venza, 2006-2010 Avalon, 2007-2010 FJ Cruiser, 2005-2011 Sienna and Sequoia, 2006-2011 Tacoma 4x2 and 4x4, Camry, Highlander, Tundra 4x2 and 4x4, and 2007-2011 Rav4 and 4Runner. The affected vehicles may experience compression of the seat cushion which may damage the seat heater wiring.

Campaign: 14V743000

AIR BAGS:SIDE/WINDOW

Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain model year 2003-2006 Toyota Land Cruiser and Lexus LX470, 2005-2006 Toyota Tundra and Sequoia, 2004-2006 Toyota 4Runner and Lexus GX470 vehicles equipped with side curtain-shield-air bags. The affected vehicles have an air bag control module that may be improperly programmed, causing the side curtain-shield-air bags to deploy inadvertently.

Campaign: 16V065000

AIR BAGS

Toyota Motor Engineering & Manufacturing (Toyota) notified the agency on May 13, 2015, that they are recalling 2005-2007 Lexus SC, Toyota Corolla, Corolla Matrix, Sequoia, and Pontiac Vibe, and 2005-2006 Toyota Tundra vehicles that were originally sold, or ever registered, in Florida, along the Gulf Coast, Puerto Rico, Hawaii, the U.S. Virgin Islands, Guam, Saipan and American Samoa. On June 16, 2015 Toyota expanded the recall to cover an additional 769,055 vehicles, including certain model year 2002-2004 Lexus SC, Toyota Sequoia, 2003-2004 Toyota Corolla Matrix, Toyota Corolla, Pontiac Vibe, and Toyota Tundra vehicles, as well the vehicles covered by the May 13, 2015 notification in the portions of Georgia, Alabama, Louisiana, Mississippi and Texas that were not previously included. The inflators in the front passenger air bags are susceptible to rupture in the event of a crash necessitating the deployment of the front passenger air bag.

Campaign: 15V286000

AIR BAGS

Toyota Motor Engineering & Manufacturing (Toyota) notified the agency on May 13, 2015 that they are recalling certain model year 2004 Sequoia vehicles manufactured August 18, 2003, to August 19, 2004, and 2003-2004 Tundra vehicles manufactured March 18, 2003, to August 25, 2004. On June 16, 2015, Toyota expanded the recall to include an additional 1,270,468 vehicles, including model year 2002-2003 and 2005-2007 Sequoia, 2005-2006 Tundra, 2003-2007 Corolla, 2003-2007 Corolla Matrix, 2003-2007 Pontiac Vibe and 2002-2007 Lexus SC vehicles. This is to address a safety defect in the passenger side frontal air bag inflator which may produce excessive internal pressure causing the inflator to rupture upon deployment of the air bag. This recall addresses both the passenger side frontal air bags that were originally installed in the vehicles, as well as replacement air bags that may have been installed as replacement service parts. A replacement air bag may have been installed, as one example, if a vehicle had been in a crash necessitating the replacement of the passenger side frontal air bag.

Campaign: 15V285000

SEATS:FRONT ASSEMBLY:SEAT HEATER/COOLER

Southeast Toyota Distributors, LLC (SET) is recalling certain 2005-2011 4Runner, Highlander, Sequoia, and Sienna, 2005-2010 Avalon and Tundra, 2006-2008 Camry Solara, 2006-2010 Highlander hybrid, 2006-2011 Rav4 and Tacoma, 2007-2010 FJ Cruiser, 2007-2011 Camry hybrid, 2009-2010 Venza, 2010-2012 Prius, 1988-1990 and 2005-2010 Camry, and 1989 and 2009-2010 Corolla vehicles equipped with aftermarket accessory seat heaters with a copper strand heating element. The electrical wiring in the seat heaters may be damaged when the seat cushion is compressed.

Campaign: 16V396000

EQUIPMENT:OTHER:LABELS

SOUTHEAST TOYOTA IS RECALLING CERTAIN MODEL YEAR 2005-2011 PASSENGER VEHICLES FOR FAILING TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 110, "TIRE SELECTION AND RIMS." THESE VEHICLES WERE SOLD WITHOUT THE REQUISITE LOAD CARRYING CAPACITY MODIFICATION LABELS.

Campaign: 10V036000

SUSPENSION:FRONT:CONTROL ARM:LOWER BALL JOINT

ON CERTAIN TRUCKS AND MINI VANS, DUE TO POSSIBLE IMPROPER FINISHING OF THE FRONT SUSPENSION LOWER BALL JOINT, SOME BALL JOINTS MAY EXPERIENCE AN INCIDENTAL DETERIORATION OF THE INTERNAL LUBRICATION. THIS MAY CAUSE THE BALL JOINT TO WEAR AND LOOSEN PREMATURELY, WHICH COULD RESULT IN INCREASED STEERING EFFORT, REDUCED VEHICLE SELF-CENTERING, AND NOISE IN THE FRONT SUSPENSION.

Campaign: 07V013000

SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS:MASTER CYLINDER

CERTAIN CARDONE MASTER CYLINDERS WITH PART NUMBERS 10-2925, 10-2987, 10-2987MZA, 10-3083, 11-3015, 11-3042, 11-3044, 11-3045, 11-3047, 11-3064, AND 11-3156, AND WITH DATE CODES LOWER THAN DCA7078 SOLD AS REPLACEMENT EQUIPMENT FOR USE ON THE VEHICLES LISTED ABOVE. THE SEAL ON MASTER CYLINDER CAN FAIL AND LEAK BRAKE FLUID.

Campaign: 07E023000

ENGINE

Starter replacement is exceptionally high, self repair impossible. There should be recall on manufacturing design of starter placement inside intake manifold amongst other impossible expectations

Chest Clip, Buckle, Harness

We have an issue with our Cosco Mightyfit LX Convertible Car Seat that we purchased in 2021 from Walmart. About 5 times now, when we have gone to get our child out of the seat, one of the straps has disconnected by itself from the rear buckle loop holder. The first time it happened we thought it may be a fluke, but given it has happened now about 5 times we are concerned about the continued use of this car seat and the safety it would provide in the case of a crash. We are concerned that if involved in a crash, one side (or both) of the chest straps would somehow come undone and our child would not be secured in his seat. Once we re-connect the strap to the buckle/loop on the back side of the car seat, it seems to be okay again for a little bit, but there is no notice or appearance of issues until some time later we go to unbuckle him and realize one strap just pulls out of the back of the seat. Additionally, the issue seems to occur regardless of installation method. It has occurred with both the latch system and the vehicle's seat belt. Issue seems to be regardless of seat installation location as we have had it happen in both the 2nd and 3rd rows. Vehicle seems to not play a factor as well. To answer the suggested questions very specifically: -What component or system failed or malfunctioned, and is it available for inspection upon request? The harness. Specifically, part of the 5-point harness that is the shoulder strap (left side usually) -How was the child’s safety put at risk? Child would not be secure in instance of crash and liable to come out of their car seat or not remain as firmly planted as designed. -Has the car seat been inspected by the manufacturer, police, insurance representatives or others? No it has not. The date listed below of when incident occurred is the most recent date this occurred, but again it has been multiple times now.

VEHICLE SPEED CONTROL,SERVICE BRAKES,FORWARD COLLISION AVOIDANCE

After several years of fighting problems with, after braking to a brief stop, the loss of power/abs grinding when accelerating and turning right, now the ABS is completely dysfunctional. Both TRC lights will turn on and usually the parking brake, and when braking at speeds less than 10mph the abs will activate and prevent bring the truck to a stop without pumping them, on dry pavement. When the ABS light turns on, then braking is possible, but all pressure is gone from brake booster and brakes sound like they're grinding, not like the sound of abs engaging. Very dangerous to drive in snow as front brakes work but drive axle doesn't disengage when the brake pedal is depressed. Regular mechanic won't engage with diagnosing issues as he feels the problem is partly computer malfunction and Toyota won't allow for used part mismatching. ABS/ECU is failed.

STRUCTURE

The contact owned a 2005 Toyota Sequoia. The contact stated that the vehicle had been taken to the dealer on August 7th, 2023, where a protective chemical coating was sprayed on the sub frame. The contact stated that after driving, he noticed that power steering fluid was leaking from the vehicle. There were no warning lights illuminated. The contact’s brother who is an independent mechanic, informed him about the source of the leak and noticed there was rust on the puncher frame. The vehicle was towed to the same local dealer, where it was placed on the lift, and it was diagnosed that the frame had rusted and was damaged beyond repair. The mechanic was able to peel and remove rust while using a screwdriver. The manufacturer was not contacted. The failure mileage was approximately 198,000.

UNKNOWN OR OTHER

Took the suv for an oil change and was brought to my attention that the frame of suv, chassis, is rusted and can break any moment. I took it to Toyota 2 years ago for the recall, and they said it was fine.

SUSPENSION

The contact owns a 2005 Toyota Sequoia. The contact stated while driving 60 MPH the rear of the vehicle lowered and the rear of the vehicle started to bounce, and the suspension warning light illuminated. The vehicle was taken to the dealer and the dealer stated that the suspension system needed to be replaced. The vehicle was not repaired. The manufacturer was not contacted. The failure mileage was 100,000. The VIN was not available.

STRUCTURE

The frame is damage by the weather.

SUSPENSION,UNKNOWN OR OTHER

2005 Sequoia class action, court ordered frame inspection & either repair or frame replacement. Never received notice of class action. Received letter stating vehicle needed to be inspected. Took to Victory Toyota, Canton, MI on Jan 5, 2018. Was told passed inspection & frame needed seal coating, did not have product. Vehicle was taken in multiple times, never completed the process. On May 6, 2019 the vehicle was taken to this dealership, a rental vehicle was provided and they did nothing and on May 21, 2019, noted the vehicle didn’t pass inspection & the campaign had expired! Per service history report from another dealership, on May 21, (the 15th day they had they had vehicle in their possession), they noted the frame did not pass inspection, also noted the repair timeline expired and they did nothing; however, they were paid to do the job they never did. The frame should of been replaced. I have photos from 2016 showing holes in the frame. I took vehicle to two other dealerships, one inspected in fall 2019 & sent 3 photos to Toyota showing the frame rusted holes but stated once Toyota makes a decision, the never change their mind. Second local dealership printed detailed Toyota repair history report showing Victory stated the vehicle did not pass inspection and that the timeline expired on the 16th day they had the vehicle!! The vehicle interior & exterior is in excellent condition but Toyota knowing refused to replace many of the frames, even though they knew the manufacturer had not made the frames correctly. Toyota has tons of money, clearly they don’t care about their product or customers safety.

STEERING,SUSPENSION

Frame deterioration has rendered the rear torque arm incapable resulting in dynamic misalignment of the rear axle. Under acceleration the vehicle veers into oncoming traffic and under deceleration it veers towards the road ditch as the axle shifts about beneath the vehicle.

SUSPENSION,AIR BAGS,SERVICE BRAKES

I tried to make apointments to local dealers they set up appointments and than don’t do nothing about it they said the don’t have any certified tech to do the job so I left with this mess not knowing when my ride is going to give. Out on me I got about 319000 miles Toyota should be proud and thank me for keeping my ride up to date I do my part to have it running good but they not doing there part to help me with these recalls please help me out.