2016 Toyota Tundra

2016 Toyota Tundra PU/CC 2WD

Overall

★★★★☆

Front Crash

★★★★☆

Side Crash

★★★★★

Rollover

★★★☆☆

2016 Toyota Tundra PU/CC 4WD

Overall

★★★★☆

Front Crash

★★★★☆

Side Crash

★★★★★

Rollover

★★★★☆

2016 Toyota Tundra PU/RC 2WD

Overall

★★★★☆

Front Crash

★★★★☆

Side Crash

★★★★★

Rollover

★★★☆☆

2016 Toyota Tundra PU/RC 4WD

Overall

★★★★☆

Front Crash

★★★★☆

Side Crash

★★★★★

Rollover

★★★★☆

2016 Toyota Tundra PU/EC 4WD

Overall

★★★★☆

Front Crash

★★★★☆

Side Crash

★★★★★

Rollover

★★★★☆

2016 Toyota Tundra PU/EC 2WD

Overall

★★★★☆

Front Crash

★★★★☆

Side Crash

★★★★★

Rollover

★★★☆☆

AIR BAGS:KNEE BOLSTER

Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2016 Tundra vehicles. The affected vehicles have a passenger knee air bag module that was attached to the instrument panel mounting brackets with incorrect bolts.

Campaign: 17V416000

STRUCTURE:BODY:BUMPERS

Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2016-2017 Tundra vehicles equipped with a resin rear step bumper and resin reinforcement brackets (vehicles with chrome step bumpers are not affected). In the event of an impact to the corner of the bumper, the resin bracket may be damaged but not be noticed.

Campaign: 17V051000

WHEELS:LUGS/NUTS/BOLTS/STUDS

Southeast Toyota Distributors, LLC (SET) is recalling certain model year 2013-2017 Toyota Tundra and Sequoia vehicles accessorized with Southeast Toyota accessory 20-inch Rockstar wheels installed by Southeast Toyota or a Southeast Toyota dealer. The Rockstar wheels were installed with lugnuts that may crack and detach.

Campaign: 17V311000

EQUIPMENT:OTHER:LABELS

Southeast Toyota Distributors, LLC (SET) is recalling certain model year 2016 Toyota Camry and Highlander, 2015-2016 Toyota Tundra, Scion FR-S, and tC vehicles. The Load Carrying Capacity Modification Label may not reflect the correct added weight of the installed accessories. As a result, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 110, "Tire Selection and Rims for Passenger Cars."

Campaign: 16V420000

STEERING:HYDRAULIC POWER ASSIST SYSTEM

Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2008-2022 Sequoia and 2007-2021 Tundra vehicles. The power steering gear assembly may have been manufactured incorrectly, which can result in an oil leak.

Campaign: 21V920000

STEERING:HYDRAULIC POWER ASSIST SYSTEM

Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain JTEKT power steering gear assembly service parts for 2007-2021 Tundra and 2008-2022 Sequoia, part numbers 44250-0C160, 44250-0C131, 44250-0C170, and 11250-0C121. The power steering gear assembly may have been manufactured incorrectly, which can result in an oil leak.

Campaign: 21E103000

ENGINE,FUEL/PROPULSION SYSTEM

2016 flex fuel toyota tundra with 118,00 miles was towed to toyota dealer in Las cruces with a no fuel issue. After the analysis it was determined the fuel pump over heated burning out conector and wiring ,but the pump was still working. According to toyota TSB 0166-19 this is a problem the can arise if the alcohol fuel density ID is not updated. I told the dealer to due repairs on vehicle even though a fuel pump was installed and reflashed at 114,000 miles. Viva toyota of las cruses advicate stated that a reflash is all the vehiles needs and does not desire to change the alchol fuel density to updated ID as per TSB-0166-19, so I am worried I will be operating a vehicle with a fuel pump that will over heat and burn out connectors again. I called Toyota complaints and they told me they cannot make a dealer do any repairs.

STRUCTURE

Bed is rusting out from the bottom in a fashion that looks very similar to a previous Tundra bed rusting issue that had a TSB and remedy from Toyota. On the driver's side bed bolt closest to the cab, the sheet metal tack welded to the bed has separated and is rusting out. Approximately 7 inches to the drivers side from that bolt. The seam sealer is also cracking. Additionally, the drivers side bed bolt closes to the tailgate has rust bubbling up from underneath approximately 1 inch to the passenger side from the bolt and also along where that sheet metal is tack welded onto the bed.

FUEL/PROPULSION SYSTEM

The fuel pump component or system failed or malfunctioned the engine tried cranking but would not start. The problem has been reproduced to an independent service center, where I was notified of a safety recall on Toyota Tundra. No other inspections have been performed. There are no warning lamps messages visible on the vehicle in question. The vehicle will not start until repeated starts are performed. Vehicle idles roughly before regaining normal idle. One other past similar incident of this type has occurred. No other

FUEL SYSTEM, GASOLINE,ENGINE

The contact owns a 2016 Toyota Tundra. The contact stated that while driving at slower speeds, the vehicle stalled while depressing the accelerator pedal. The check engine warning light was illuminated. The vehicle was towed to a local dealer to be diagnosed. The contact was informed that the fuel pump and other fuel pump-related parts needed to be replaced. The vehicle was not repaired because the parts were on back order. The manufacturer was made aware of the failure. The failure mileage was approximately 67,000.

STEERING

The steering rack internal seal inside the steering rack failed/ "blew" per mechanic and is leaking. I could lose my ability to steer at any time while driving my vehicle and wreck. It is currently at the Toyota services center in Gladstone, OR and has been diagnosed. No other representatives have inspected the vehicle. There were no warnings or signs of failure. I had originally taken my truck in to have an oil change and have it checked for a "slow" start up.

STEERING

The power steering went out during routine around-town driving. One moment it was steering fine, the next moment it became extremely difficult and sluggish. There were no warning lights or warning of any sort until the steering wheel started jerking unevenly as I tried to turn. I was able to get control of the vehicle and pull it to the side of the road. There was no difference in the engine noise, and I couldn't see any noticeable fluid leak. I was able to drive the vehicle home, make an appointment with the Toyota dealer, and get the vehicle to the dealership for inspection. The dealership told me after inspection, that the rack and pinion steering was binding internally, and that there was seepage from the right boot. Initially, they told me that the pump should be fine. I authorized them to replace the rack and pinion steering. After which, they told me that the problem seemed to still persist some, and that the pump would have to be replaced also. My total bill came to $3,200, which seemed not unfair. But this whole issue seemed like something that should be noticed as part of a recall. I found the NHTSA recall number. 21V-920, and my truck seemed to match exactly the symptoms spelled out is this recall , but Toyota refused to acknowledge it. My VIN number did not fall within the specified VIN for this recall. I've driven several Toyotas, including another Tundra, a Tacoma, 2 Highlanders and a Sienna, and have been pleased with each vehicle. This Tundra is 10 years old with 95,000 miles, and I've only done expected maintenance and a couple of occasional minor repairs. Those being: - Having the brakes resurfaced - Changing out the alternator In the end, it wasn't a devastating amount of money, but it was an issue that I felt Toyota should have taken care of. I did reach out to them, but because I had already paid for the repairs on the vehicle I needed to drive for work, they refused to talk to me any further. I have the estimate and final bill.

EXTERIOR LIGHTING

My right front headlamp is getting moisture inside the headlamp assembly. It can be inspected any time. Chance that headlamp will not work. Did not take to a dealer.

ELECTRICAL SYSTEM

Odometer Fraud. The contact purchased a 2016 Toyota Tundra. The contact stated while going through prior service paperwork found in the vehicle, he discovered that there was a mileage discrepancy. The vehicle was a private sale. The contact also stated that the vehicle was once sold at a private auction. At the time of purchase, the vehicle mileage was 158,000; however, upon discovery of the service paperwork, the contact discovered that the vehicle mileage was once 250,000.

STRUCTURE

I have had multiple incidents where the front hood bulge has blown off going down the interstate and nearly hit other cars. It’s not been worth buying a new one with the risk of them flying off. It’s definitely a saftey concern and a hazard.

SERVICE BRAKES

The trailer brake controller went out. It does not supply electronic braking and the truck no longer recognizes the controller on the dashboard. Multiple on line chats and forums, along with my trailer provider, show awareness of this defect. Online individuals learned of the issue during emergency stopping. This appears to be known and wide spread.